You can assemble laser-cut parts into a construction yourself. Good assembly starts in the drawing: parts must remain accessible, align correctly and receive support where needed. Glue does not solve an incorrect fit.
Try the joint without glue
Dry-fit a trial set. Do parts slide into place without force? Are corners square, and is there enough bonding area? A slightly undersized slot can damage a thin part before assembly is complete.
Read about tolerances and fit for dimensional differences and slot sizes.
Choose adhesive for the actual surface
Untreated wood, a dark cut edge and a painted face are different bonding surfaces. Follow the adhesive manufacturer's instructions and test the same material and finish combination. Remove loose residue and dust before bonding.
Support parts while they dry
A flat surface, jig or clamp can hold the position. Distribute pressure so a small contact area is not crushed. Plan assembly order: a wall glued into place can block access to the next joint.
Consider painting and later disassembly
Loose parts are often easier to paint. Keep bonding surfaces clear if the adhesive needs bare material. Paint can also make a slot tighter.
If the product must come apart, use a suitable mechanical joint where possible. Read about finger joints, snap fits and press fits. We supply the laser-cut parts; this guide covers your own assembly after delivery.